Nashville's Flooring — Middle Tennessee (615) 560-9744 Free Estimate
Home Hardwood Installation Hardwood Refinishing Luxury Vinyl Plank Tile & Showers Carpet Subfloor & Repairs Service Area Ground Floor About Get a Free Estimate

Flooring · Nashville, TN

Does LVP Need to Acclimate? What the Makers Say

One maker says vinyl plank needs no acclimation, another says 48 hours, and one maker says both for different lines. What four installation guides actually require, and how we work from them.

We respond immediately Licensed and insured local crews Free, no-obligation estimates

· by Michael Blair, Nashville's Flooring

Whether luxury vinyl plank has to sit in the house before it goes down is a question with more than one right answer. The manufacturers disagree, and one manufacturer gives different instructions for two of its own product lines. So the real answer is that the installation sheet for the plank you bought decides it. Here is what four of those sheets say about acclimation, temperature, expansion gaps and sunny rooms, and how we work from them on an LVP installation.

Does LVP need to acclimate before it goes down?

Whether LVP needs to acclimate depends on the product, and the instructions range from not required to 48 hours. Shaw’s COREtec Scratchless installation guide says acclimation is not required, provided the floor goes into a climate-controlled space between 55°F and 85°F, or one averaging 70°F. Shaw’s COREtec Stone installation guide, from the same maker, recommends 48 hours of acclimation if the boxes were stored outside that 55°F to 85°F range beforehand.

Hallmark Floors’ EZ Loc Courtier rigid plank instructions (2024) say acclimation is not always needed, but the room has to hold 55°F to 85°F from 48 hours before installation until 48 hours after, and planks arriving from outside that range should sit on site until they match the indoor temperature, which can take 12 to 24 hours. Kraus Flooring’s dry-back glue-down LVT instructions are the strictest of the four: 64°F to 85°F, with the flooring acclimated in the conditioned space for 48 hours before, during and after the work.

Why do LVP makers disagree on acclimation?

LVP makers disagree on acclimation because each installation sheet is written for one construction, and a rigid floating plank, a stone-core plank and a thin glue-down vinyl are not built alike even when the boxes look similar. Where all four guides agree is the temperature window. None of them treats acclimation as a fixed waiting period for its own sake; each cares whether the planks and the room are inside its stated range when the floor goes down.

That window is the part that matters in Middle Tennessee. Boxes that spent a July afternoon in a hot truck, or a January night in an unheated garage, can arrive well outside 55°F to 85°F even when the house itself is comfortable. So we read the sheet for the exact plank, check the boxes and the room, and give it whatever time that sheet asks for. Every one of these guides assumes a room held inside its range, so a house with the heat and air not yet running is not ready for vinyl. How the rest of a job is scheduled is in our post on the flooring installation timeline.

How much expansion gap does LVP need?

Most floating LVP needs a 1/4-inch gap at the walls, with more on large floors, but each maker sizes that increase its own way. Both COREtec guides go by floor area: 1/4 inch for areas under 2,500 square feet and 1/2 inch above that. Hallmark goes by span instead: 1/4 inch covers a floor up to 50 feet long or wide, then 1/16 inch more for each additional 5 feet, up to 80 feet and 1/2 inch, or the floor is broken with a transition molding.

Glue-down vinyl works on a different basis. Kraus’s instructions call for at least 5 mm of expansion space and a transition molding once a run passes 35 linear feet, and those figures belong to that product, not to a floating floor. Anything installed on top of the floor changes the picture as well: COREtec’s Scratchless guide says the area under cabinets must be fully glued to the subfloor rather than left floating. The gap ends up hidden under baseboard or quarter round, which makes it easy to skip and hard to correct later.

Can LVP go in a sunroom?

LVP can go in a sunroom only where the product’s instructions allow it, and two of these four set conditions for it. COREtec Scratchless allows a three-season room to range from -25°F to 155°F after installation, for floating floors only and not glue-down. Hallmark allows three-season rooms with at least 1/2 inch of expansion space, and with the room at 55°F to 85°F and 30 to 55 percent relative humidity for 48 hours before, during and after the install.

Sunlight is a separate problem from air temperature. COREtec warns that long exposure to direct sun can discolor the Scratchless floor and suggests drapes or blinds during peak hours, and its Stone guide says heat from direct sunlight can cause thermal expansion. Hallmark’s general guideline is not to install in direct sunlight, and Kraus asks for windows to be blacked out from 24 hours before a glue-down install until 24 hours after. A sunroom that takes the afternoon sun is where those limits matter most, so we choose the product by its sheet before its color. Compare floor types in LVP versus hardwood, and ask us to measure the room.

Sources

FAQ

Does LVP Need to Acclimate? What the Makers Say — questions

How long does LVP need to acclimate?

It depends on the product. Shaw’s COREtec Scratchless guide says no acclimation is required in a 55°F to 85°F room; COREtec Stone recommends 48 hours if the boxes were stored outside that range; Hallmark allows 12 to 24 hours for planks arriving out of range; and Kraus’s glue-down LVT asks for 48 hours.

Can LVP be installed without acclimating?

Some LVP can. Shaw’s COREtec Scratchless instructions say acclimation is not required, and Hallmark says it is not always needed for its rigid plank, but both require the room to be held between 55°F and 85°F. If the planks were stored outside that range, the instructions call for time to adjust first.

Does LVP expand and contract with temperature?

The makers write their instructions as though it does. COREtec’s Stone guide says heat from direct sunlight can cause thermal expansion, and Kraus asks for windows to be blacked out around a glue-down install to prevent thermally induced changes in the floor. That is why every guide sets a temperature range and an expansion gap.

Does LVP need an expansion gap?

Floating LVP does. COREtec’s guides call for 1/4 inch at the walls on floors under 2,500 square feet and 1/2 inch above that, and Hallmark calls for 1/4 inch up to a 50-foot span, adding 1/16 inch for each additional 5 feet. Kraus’s glue-down vinyl asks for at least 5 mm.

Free estimate

Thinking about new floors? Start with a measure

Tell Nashville's Flooring the rooms and the floor you are leaning toward, and a written estimate, tear-out included, comes back at no cost and without any obligation.

Call Chat Free Estimate
New floors or refinishing?